Applying Vinyl Siding Starter Strip

Snap a level chalk line for the first starter strip at the base of the wall no less than 8 inches above ground level after determining the lowest corner of the house.

Applying vinyl siding starter strip.

Be sure to center the nails in their slots to. Insulation for vinyl siding 1. Pop a level chalk line for the starter strip an inch or two above the bottom of the siding. Hold a tape measure against the exterior wall and travel.

Pull up as. Locate the lowest possible corner that has sheathing. Attach j channel trim strips around windows and doors and along the eaves. Pull the zip tool down while simultaneously.

Nail vertical vinyl corners to the corners of the house making sure they are plumb. Slide it into the corner and nail it every 16 in. Position starter strip with the top edge of chalk line and allow room for corner posts. Vinyl siding starter strips.

Cap the corner posts. This chalk line should be level and a consistent distance from the eaves or the top and bottom of the windows. 13 simple vinyl siding installation tips use the wider starter strip. How to install a vinyl siding starter strip step 1.

Find the lowest corner of the old siding or sheathing on the house. The bottom of the starter strip the part the bottom panel hooks on to should be at least. Determine the lowest point of the wall that will be sided. In order for the siding to be installed properly in a level fashion the starter strip at the bottom of the wall must be level.

From that point measure up 1 4 6 4mm less than the width of the starter strip and partially drive a nail at one corner. Snap each length of siding in place so that its bottom lip hooks under the starter strip. This is where the new siding will begin. Partly drive a nail 11 2 in.

This video shows how to install a starter strip for vinyl and polymer siding installation. Measure a spot that is 1 1 2 inches above the bottom edge of the sheathing at this lowest point using a tape. Nail the starter strip to the siding aligning the top of the strip with the chalk line. Insert the flat hooked end of the zip tool under the lip on the bottom most edge of the vinyl siding panel that rests on top of the starter strip.